Table of Contents
Being prepared for remote flying is essential – particularly if you have never done it before. As we all know. – fuel is one essential for flying, and there are massive distances between fuel outlets in the Australian outback.
Do you have enough fuel?
When the fuel runs low you will need an airfield with three things:
- A suitable runway to land on.
- A suitable runway for take-off – not necessarily the same thing, and
- The correct grade of fuel, plus a means of getting it into your aircraft!
Too rough? Too short? Too much slope?
There are Many Factors that Impact Airstrip Safety
Suitable for landing means it must be long enough, the approach and overshoot must be clear, it must be flattish, smoothish and strong enough. It must have no ditch across it, the rain must not have eroded its surface, and you must be able to see all this by doing a fly-past – long grass must not be hiding these imperfections. The camber must not be too severe for your level of experience. It can play hell with directional control. Bush strips are often heavily cambered to prevent standing water.
What happened to my braking? A sticky end to the landing roll on a nice wet grass strip.
Is the Airstrip Black Earth?
If it is black earth, make sure it is not very wet, because then it’s soft and likely to get you bogged. Or slightly wet, because it sticks to your wheels and tears the spats off. Or very very dry because it develops cracks that can eat your nose-wheel. Black earth absorbs water so readily that it’s difficult to see how wet it is. Check for dust on nearby roads.
If it is red earth look out for greener patches that can hide mud or water.
Be prepared for remote flying: Are you landing on a Claypan?
Claypans, which are brilliant landing areas when dry, become ice rinks when wet. Saltpans can be like after-dinner mints – hard on the outside and soft underneath – be very careful!
Landing on a saltpan takes some prep to pull it off successfully. This mob in Africa are used to it!
Didn’t know you were allowed to land on pans? Actually you can land pretty well anywhere that conforms to two requirements.
First, you must have permission from the owner or caretaker of the ground, and second, you must establish that it’s safe for landing and take-off. You can do this from the air. Obviously if anything goes wrong you failed to comply with the second requirement and therefore contravened the law. Also check that the aircraft insurance covers unlicensed fields.
The remote bush strip of Faraway Bay on the northern Kimberley coast.
Be prepared for remote flying: Is the Airstrip Wide Enough?
The narrowness of bush strips often makes them look longer than they are. If in doubt fly over it at 100kts into wind, and time it (about 50m per sec). Ten seconds will give you the equivalent of 500m – it will only be an actual 500m if there is no wind. Be sure you understand the implications. Doing it into wind, the runway will be shorter than you measure, but it should be OK for landing because of the headwind. However you may find yourself wanting to take off on it tomorrow with no wind – and full tanks.
Bush strips are sometimes built for the owner’s STOL aircraft and are not designed for city-based road-runners. They may have only one direction because of wires or other obstructions. They are often near the homestead – and a radio mast.
They tend to harbour bits of barbed-wire, animal-holes, and soft or slippery patches. Windsocks blow away.
Windmills don’t always point into wind – some are rusted and some have the tail pulled round. There are seldom tie-downs – take your own. Some strips double as roads and may be corrugated or have traffic.
Natural surface outback airstrips are often hiding right in front of you
Beware the hazards of long grass
A grass surface can hide obstructions, and cause braking issues when wet or frosty. Long grass can double the length of your take-off run. Also the seeds can block your air intakes as well as pitot, static and breather vents. If the grass is long and dry you can set fire to it with your exhaust.
In soft sand let plenty of air out of your tyres for taxiing and take-off – it makes an unbelievable difference.
Don’t Fly Low over Sand Dunes
Always resist the urge to fly low over sand or dunes – their height is unbelievably deceptive and you can collide with one before you know what’s hit you.
If in doubt, walk the area before using it – there is nothing more frustrating than landing successfully, and then taxiing into a hole and bending the prop.
Always Check Country Airstrips before Landing
Country people like to be visited. When you phone to ask about their strip, they have a vested interest and may tell you it’s fine. Don’t believe them. Ask penetrating questions about the length, the surface, the approaches, the wetness and all the other good things – like when was the last time someone landed there and what sort of aircraft?
Lastly there is the question of weather – and that will be another article!
Conclusion
One of the joys of flying light aircraft in Australia is the vast number of small country airstrips available. Flying into these airstrips can be very rewarding – great scenery and locations.
However – many remote airstrips are only lightly used, do not have regular maintenance, have no facilities including fuel and have many other traps for the unprepared pilot. If you follow the advice given above you will greatly minimise the chance of a mishap. Enjoy your trip!
